|
V2
Amp on/off
Amp button turns unit on and toggles between two pre-amp
settings. Amp-1 is setup to work best with single
coil pickups and is indicated with
green LED.
Amp-2 is optimized for double coil pickups and is
indicated with red LED.
The unit can be turned off by holding down the Amp
button for 3 seconds.
LED
Three colored LED light indicates that the unit is on
and operating. LED changes color from
red,
green
and yellow
depending on what effect or function is engaged.
Delay:
Button allows user to select Double, Chorusing,
Flange or no delay effect.
Reverb:
Button allows user to select Slapback, Club-Reverb,
Hall-Reverb or no reverb effect.
Clean:
Button selects between three (3) distinct clean tube
amp tones. Each tone has a natural, not overly
compressed sound, rich in harmonic content and
dynamic range.
Dirty:
Button selects between three (3) distinct tube style
distortion tones. Position one has a Fender-like
crunch. Position two has the Marshall overdrive
sound, and position three is a highly compressed heavy
metal overdrive tone. Each tone is natural, with
rich harmonic content and wide dynamic range.
Level:
This is a two-position button that controls the intensity
of the delay effects. You can select a Hi or Low
intensity level. This button is only active when
a Delay or Reverb effect has been engaged.
Tuner:
Button scrolls through six guitar strings starting with
low E. Each string selected emits a tuning tone that
can be used to tune appropriate string. While tuning,
LED light will indicate red if string is too flat and green
if string is too sharp. When string is in tune LED
will turn yellow.
Click:
Button engages click track. Button scrolls between
off position and hi and low volume.
Tempo:
Button scrolls through eight different click tempo drum
beats between 60 and 180 bpm.
Filter:
Continuously variable EQ control that adjusts high and
mid-range frequencies of the particular amp emulation model
selected.
Volume:
Master volume control slider controls the overall volume
level of line out / headphone out signal.
line out:
Provides a stereo line level signal for headphones or
various recording and pre-amp applications.
line in:
Accepts stereo line level input from MP3 player or any
other external source. Allows you to play along
and simultaneously monitor both sounds. Volume
control on the V2 does not affect the volume level of
the external source.
Input plug:
Rotating input plug has 90 degree range of motion,
with preset stops at 0, 30, 60 and 90 degrees.
Enables unit to plug into any guitar jack.
Headphones:
Acoustically matched light weight stereo headphones with
1.0oz magnets and super bass 40mm diameter drivers.
Cable Kit:
1/8" to 1/8" stereo mini plug cable 6' long, a 1/8"
stereo headphone splitter, a 1/8" to 1/4" stereo
adapter plug and a mono 1/4" to 1/4" female adapter tube.
|
